Comparative Study of MIL-96(Al) as Continuous Metal–Organic Frameworks Layer and Mixed-Matrix Membrane

详细信息    查看全文

• 作者：Alexander Knebel ; Sebastian Friebe ; Nadja Carola Bigall ; Marvin Benzaqui ; Christian Serre ; Jürgen Caro
• 刊名：ACS Applied Materials & Interfaces
• 出版年：2016
• 出版时间：March 23, 2016
• 年：2016
• 卷：8
• 期：11
• 页码：7536-7544
• 全文大小：637K
• ISSN：1944-8252

文摘

MIL-96(Al) layers were prepared as supported metal–organic frameworks membrane via reactive seeding using the α-alumina support as the Al source for the formation of the MIL-96(Al) seeds. Depending on the solvent mixture employed during seed formation, two different crystal morphologies, with different orientation of the transport-active channels, have been formed. This crystal orientation and habit is predefined by the seed crystals and is kept in the subsequent growth of the seeds to continuous layers. In the gas separation of an equimolar H₂/CO₂ mixture, the hydrogen permeability of the two supported MIL-96(Al) layers was found to be highly dependent on the crystal morphology and the accompanied channel orientation in the layer. In addition to the neat supported MIL-96(Al) membrane layers, mixed-matrix membranes (MMMs, 10 wt % filler loading) as a composite of MIL-96(Al) particles as filler in a continuous Matrimid polymer phase have been prepared. Five particle sizes of MIL-96(Al) between 3.2 μm and 55 nm were synthesized. In the preparation of the MIL-96(Al)/Matrimid MMM (10 wt % filler loading), the following preparation problems have been identified: The bigger micrometer-sized MIL-96(Al) crystals show a trend toward sedimentation during casting of the MMM, whereas for nanoparticles aggregation and recrystallization to micrometer-sized MIL-96(Al) crystals has been observed. Because of these preparation problems for MMM, the neat supported MIL-96(Al) layers show a relatively high H₂/CO₂ selectivity (≈9) and a hydrogen permeance approximately 2 magnitudes higher than that of the best MMM.