Influence of aging methods on push-out bond strength of adhesive systems to dentin cavities

详细信息    查看全文

• 作者：Letícia Virgínia de Freitas Chaves ; Tuany Arantxa de Medeiros…
• 关键词：Thermal cycling ; Mechanical loading ; Push ; out ; Bond durability
• 刊名：Applied Adhesion Science
• 出版年：2017
• 出版时间：December 2017
• 年：2017
• 卷：5
• 期：1
• 全文大小：822KB
• 刊物类别：Surfaces and Interfaces, Thin Films; Mechanical Engineering; Biomaterials;
• 刊物主题：Surfaces and Interfaces, Thin Films; Mechanical Engineering; Biomaterials;
• 出版者：Springer International Publishing
• ISSN：2196-4351
• 卷排序：5

文摘

This study evaluated the effect of aging methods on the bond strength of etch-and-rinse adhesive systems to dentin cavities. Eighty bovine incisors were used to prepare dentin cavities, which were bonded with different adhesive systems [Adper Scotchbond Multipurpose (SBMP), and Adper Single Bond 2 (SB)], and restored with composite resin. The specimens were stored in water for 24 h, and subjected to each aging method (n = 10): control group (not exposed to additional aging), thermal cycling (TC) (10,000 cycles; at temperatures of 5, 37, and 55 °C), mechanical loading (ML) (100,000 cycles; Hz; 60 N load), and TC + ML. The push-out bond strength test was performed using a universal testing machine. Failure modes were evaluated by scanning electron microscopy. Data were analyzed by two-way ANOVA and Tukey’s test (α = 0.05). For SBMP, only TC + ML decreased the bond strength compared to control group. For SB, all aging methods decreased similarly the bond strength compared to control group. A high number of adhesive failures were observed. Therefore, SB was sensitive to all aging methods, whilst only TC + ML was able to decrease the bond strength for SBMP.