High-efficiency Cu₂ZnSn(S,Se)₄ solar cells fabricated through a low-cost solution process and a two-step heat treatment

详细信息    查看全文

• 作者：Shih-Hsiung Wu ; Chia-Wen Chang ; Hui-Ju Chen ; Chuan-Feng Shih ; Yu-Yun Wang ; Chou-Cheng Li and Sheng-Wen Chan
• 刊名：Progress in Photovoltaics: Research and Applications
• 出版年：2017
• 出版时间：January 2017
• 年：2017
• 卷：25
• 期：1
• 页码：58-66
• 全文大小：2623K
• ISSN：1099-159X

文摘

A method for fabricating high-efficiency Cu₂ZnSn(S,Se)₄ (CZTSSe) solar cells is presented, and it is based on a non-explosive, low-cost, and simple solution process followed by a two-step heat treatment. 2-Methoxyethanol was used as a solvent, and Cu, Zn, Sn, chloride salts, and thiourea were used as solutes. A CZTSSe absorber was prepared by sulfurising and then selenising an as-coated Cu₂ZnSnS₄ (CZTS) film. Sulfurisation in a sulfur vapour filled furnace for a long time (2 h) enhanced the crystallisation of the as-coated CZTS film and improved the stability of the CZTS precursor, and selenisation promoted further grain growth to yield a void-free CZTSSe film. Segregation of Cu and S at the grain boundaries, the absence of a fine-grain bottom layer, and the large grain size of the CZTSSe absorber were the main factors that enhanced the grain-to-grain transport of carriers and consequently the short-circuit current (J_sc) and efficiency. The efficiency of the CZTS solar cell was 5.0%, which increased to 10.1% after selenisation. For the 10.1% CZTSSe solar cell, the external quantum efficiency was approximately 80%, the open-circuit voltage was 450 mV, the short-circuit current was 36.5 mA/cm², and the fill factor was 61.9%. Copyright