High Density Ozone Monitoring Using Gas Sensitive Semi-Conductor Sensors in the Lower Fraser Valley, British Columbia

详细信息    查看全文

• 作者：Mark Bart ; David E Williams ; Bruce Ainslie ; Ian McKendry ; Jennifer Salmond ; Stuart K. Grange ; Maryam Alavi-Shoshtari ; Douw Steyn ; Geoff S. Henshaw
• 刊名：Environmental Science & Technology
• 出版年：2014
• 出版时间：April 1, 2014
• 年：2014
• 卷：48
• 期：7
• 页码：3970-3977
• 全文大小：559K
• 年卷期：v.48,no.7(April 1, 2014)
• ISSN：1520-5851

文摘

A cost-efficient technology for accurate surface ozone monitoring using gas-sensitive semiconducting oxide (GSS) technology, solar power, and automated cell-phone communications was deployed and validated in a 50 sensor test-bed in the Lower Fraser Valley of British Columbia, over 3 months from May鈥揝eptember 2012. Before field deployment, the entire set of instruments was colocated with reference instruments for at least 48 h, comparing hourly averaged data. The standard error of estimate over a typical range 0鈥?0 ppb for the set was 3 卤 2 ppb. Long-term accuracy was assessed over several months by colocation of a subset of ten instruments each at a different reference site. The differences (GSS-reference) of hourly average ozone concentration were normally distributed with mean 鈭? ppb and standard deviation 6 ppb (6000 measurement pairs). Instrument failures in the field were detected using network correlations and consistency checks on the raw sensor resistance data. Comparisons with modeled spatial O₃ fields demonstrate the enhanced monitoring capability of a network that was a hybrid of low-cost and reference instruments, in which GSS sensors are used both to increase station density within a network as well as to extend monitoring into remote areas. This ambitious deployment exposed a number of challenges and lessons, including the logistical effort required to deploy and maintain sites over a summer period, and deficiencies in cell phone communications and battery life. Instrument failures at remote sites suggested that redundancy should be built into the network (especially at critical sites) as well as the possible addition of a 鈥渟leep-mode鈥?for GSS monitors. At the network design phase, a more objective approach to optimize interstation distances, and the 鈥渋nformation鈥?content of the network is recommended. This study has demonstrated the utility and affordability of the GSS technology for a variety of applications, and the effectiveness of this technology as a means substantially and economically to extend the coverage of an air quality monitoring network. Low-cost, neighborhood-scale networks that produce reliable data can be envisaged.