Consecutive Morphology Controlling Operations for Highly Reproducible Mesostructured Perovskite Solar Cells

详细信息    查看全文

• 作者：Yongzhen Wu ; Wei Chen ; Youfeng Yue ; Jian Liu ; Enbing Bi ; Xudong Yang ; Ashraful Islam ; Liyuan Han
• 刊名：ACS Applied Materials & Interfaces
• 出版年：2015
• 出版时间：September 23, 2015
• 年：2015
• 卷：7
• 期：37
• 页码：20707-20713
• 全文大小：395K
• ISSN：1944-8252

文摘

Perovskite solar cells have shown high photovoltaic performance but suffer from low reproducibility, which is mainly caused by low uniformity of the active perovskite layer in the devices. The nonuniform perovskites further limit the fabrication of large size solar cells. In this work, we control the morphology of CH₃NH₃PbI₃ on a mesoporous TiO₂ substrate by employing consecutive antisolvent dripping and solvent-vapor fumigation during spin coating of the precursor solution. The solvent-vapor treatment is found to enhance the perovskite pore filling and increase the uniformity of CH₃NH₃PbI₃ in the porous scaffold layer but slightly decrease the uniformity of the perovskite capping layer. An additional antisolvent dripping is employed to recover the uniform perovskite capping layer. Such consecutive morphology controlling operations lead to highly uniform perovskite in both porous and capping layers. By using the optimized perovskite deposition procedure, the reproducibility of mesostructured solar cells was greatly improved such that a total of 40 devices showed an average efficiency of 15.3% with a very small standard deviation of 0.32. Moreover, a high efficiency of 14.9% was achieved on a large-size cell with a working area of 1.02 cm².