Scalable Binder-Free Supersonic Cold Spraying of Nanotextured Cupric Oxide (CuO) Films as Efficient Photocathodes

详细信息    查看全文

• 作者：Jong Gun Lee ; Do-Yeon Kim ; Jong-Hyuk Lee ; Min-woo Kim ; Seongpil An ; Hong Seok Jo ; Carlo Nervi ; Salem S. Al-Deyab ; Mark T. Swihart ; Sam S. Yoon
• 刊名：ACS Applied Materials & Interfaces
• 出版年：2016
• 出版时间：June 22, 2016
• 年：2016
• 卷：8
• 期：24
• 页码：15406-15414
• 全文大小：604K
• 年卷期：0
• ISSN：1944-8252

文摘

We demonstrate production of nanotextured p-type cupric oxide (CuO) films via a low-cost scalable supersonic cold spray method in open air conditions. Simply sweeping the spray nozzle across a substrate produced a large-scale CuO film. When used as hydrogen evolution photocathodes, these films produced photocurrent densities (PCD) of up to 3.1 mA/cm² under AM1.5 illumination, without the use of a cocatalyst or any additional heterojunction layers. Cu₂O particles were supersonically sprayed onto an indium tin oxide (ITO) coated soda lime glass (SLG) substrate, without any solvent or binder. Annealing in air converted the Cu₂O films to CuO, with a corresponding decrease in the bandgap and increase in the fraction of the solar spectrum absorbed. Annealing at 600 °C maximized the PCD. Increasing the supersonic gas velocity from ∼450 to ∼700 m/s produced denser films with greater surface roughness, in turn producing higher PCD. The nanoscale texture of the films, which resembles the skin of a dinosaur, enhanced their performance, leading to one of the highest PCD values in the literature. We characterized the films by X-ray diffraction, Raman spectroscopy, X-ray photoelectron spectroscopy, atomic force microscopy, scanning electron microscopy, and transmission electron microscopy to elucidate the origins of their outstanding performance. This supersonic cold spraying deposition has the potential to be used on a commercial scale for low cost mass production.