Influence of Photolithography on the Cross-Sectional Shape of Polysiloxane as an Optical Waveguide Material on Printed Circuit Boards

详细信息    查看全文

• 作者：Kam-chuen Yung (1)
  Chung-pang Lee (1)
  Ching-hong Wong (1)
  Siu-lim Tam (1)
  Siu-kwong Pang (1)
  Tai-man Yue (1)
  
• 关键词：Optical printed circuit boards ; optical waveguides ; photolithography ; cross ; sectional shape ; polysiloxane
• 刊名：Journal of Electronic Materials
• 出版年：2013
• 出版时间：December 2013
• 年：2013
• 卷：42
• 期：12
• 页码：3494-3501
• 全文大小：
• 作者单位：Kam-chuen Yung (1)
  Chung-pang Lee (1)
  Ching-hong Wong (1)
  Siu-lim Tam (1)
  Siu-kwong Pang (1)
  Tai-man Yue (1)
  
  1. Department of Industrial and Systems Engineering, PCB Technology Centre, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong
  
• ISSN：1543-186X

文摘

Optical waveguide cross-sectional shapes that deviate from rectangles or squares may cause significant loss of signal. In this study, a photolithography approach was adopted to fabricate waveguides on printed circuit boards, using photo-imageable polysiloxane as a waveguide material. The effects of I-line ultraviolet (UV) lamp exposure, 355-nm Nd:YAG laser direct imaging, and 248-nm excimer laser direct imaging on the cross-sectional shape of waveguides were investigated. For I-line UV lamp exposure, increasing the exposure time could cause changes in the tilt angle of the waveguides from negative (inverted trapezoid) to positive (trapezoid). To obtain rectangular waveguides, the optimum I-line UV lamp exposure time was found to be around 150?s. From the results for 355-nm Nd:YAG laser direct imaging, the width and tilt angle of the waveguides varied with the energy density of the laser beam irradiating the core materials, being controlled by the repetition rate and focus. Lowering the laser energy density could produce waveguides with small widths and tilt angles. Excimer laser direct imaging at 248?nm was found to be unsuitable for waveguide patterning since the core materials could not be cured at this wavelength.